Please use this identifier to cite or link to this item: https://hdl.handle.net/10216/158524
Full metadata record
DC FieldValueLanguage
dc.creatorAntónio Viana da Fonseca
dc.creatorCristiana Ferreira
dc.creatorFredy Alonso Diaz Duran
dc.creatorGiovanni Cascante
dc.date.accessioned2024-05-10T23:06:35Z-
dc.date.available2024-05-10T23:06:35Z-
dc.date.issued2021-05-06
dc.identifier.issn0149-6115
dc.identifier.othersigarra:507740
dc.identifier.urihttps://hdl.handle.net/10216/158524-
dc.description.abstractBender elements (BEs) have become a routine geotechnical laboratory tool for seismic wave velocity measurements. Since the 1980s, this testing technique has gained popularity, currently being available in many geotechnical laboratories worldwide in a variety of apparatuses. The advantage of simultaneously measuring small- and large-strain soil stiffnesses in each device and the easiness and low-cost implementation of BE are the main reasons for their common application. Although there is already a standardized procedure for BE testing (ASTM D8295-19, Standard Test Method for Determination of Shear Wave Velocity and Initial Shear Modulus in Soil Specimens Using Bender Elements), the use of high-frequency pulses for the simultaneous measurement of compressional (V-p) and shear (V-s) wave velocities is not considered. In contrast, the use of high-excitation frequencies is usually discouraged, as they tend to induce spurious participation of high-vibration modes in the BE response. However, this work shows that the use of higher vibration modes can be advantageous to evaluate P-wave velocities from standard BE testing. Thus, this paper presents a new approach for the concurrent measurements of V-p and V-s using a typical installation of BE. The new approach is first demonstrated by experimental measurements and subsequently validated using high-frequency laser vibrometer measurements of the actual BE deformation (nanometer scale) under different excitation frequencies. The laser vibrometer measurements show the displacements of the transmitter BE as a function of the input frequency in not only the horizontal but also in the vertical directions, demonstrating the generation of P-waves when higher vibration modes are excited. The measured V-p values are shown to be in good agreement with the predicted values using Biot's equations. Thus, the proposed methodology addresses the current knowledge gap in the use of BE for concurrent P-wave and S-wave velocity measurements. The generated wavelengths are large enough to travel through the soil skeleton instead of the pore water only.
dc.language.isoeng
dc.rightsrestrictedAccess
dc.subjectGeotecnia, Engenharia civil
dc.subjectGeotechnics, Civil engineering
dc.titleNew Approach to Concurrent V-s and V-p Measurements Using Bender Elements
dc.typeArtigo em Revista Científica Internacional
dc.contributor.uportoFaculdade de Engenharia
dc.identifier.doi10.1520/gtj20200207
dc.identifier.authenticusP-00V-K8G
dc.subject.fosCiências da engenharia e tecnologias::Engenharia civil
dc.subject.fosEngineering and technology::Civil engineering
Appears in Collections:FEUP - Artigo em Revista Científica Internacional

Files in This Item:
File Description SizeFormat 
507740.pdf
  Restricted Access
2.03 MBAdobe PDFView/Open


Items in DSpace are protected by copyright, with all rights reserved, unless otherwise indicated.